[Spridgets] FW: Wheel Stud

corvallis at peoplepc.com corvallis at peoplepc.com
Mon Aug 9 12:51:58 MDT 2010


Obviously a person to be taken seriously:
"Driving his 1967 MG Midget, Robert Spruck '65 became the F-Production 2001
Vintage National Champion last December at Roebling Road Raceway just
outside Savannah, Ga."  ...bill in corvallis
http://www.lafayette.edu/news.php/view/111
========================================================
-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net] On Behalf Of Bob Spruck
Sent: Monday, August 09, 2010 9:38 AM
To: Kirk Hargreaves; spridgets at autox.team.net
Subject: Re: [Spridgets] Wheel Stud

I replaced the stock 3/8 " studs on my '67 vintage race car with 
7/16" studs from Pep Boys just to gain the extra strength and length. 
I removed the four hubs and drilled the holes in the hubs to the 
correct diameter to accommodate the serrations on the studs and 
pressed them in. I also opened up the holes in the drums and axles on 
the rear. I drew them tight by bolting them to a wheel which also 
insured all four were parallel to each other.

After quite a few on-off cycles of race tires, rain tires, garage 
tires, and other maintenance, one stud spun and I had to use a 
ziz-wheel to cut through the nut and stud. The permanent fix involved 
bolting the hubs to a wheel to insure parallelness and putting a spot 
of weld on the backside where the head of the larger stud sits 
against the back surface of the hub. I did this on all 16 studs just 
to make sure. Never a problem since.

I wrote an article for the defunct Sprite/Midget Magazine with all 
the details, including part numbers, sizes, photos, etc. that I can 
send you off list if you want.

Bob
==================================
At 10:17 AM 8/9/2010, Kirk Hargreaves wrote:
>I snapped a wheel stud with my air wrench (weak SOB).   Came off with not
>much pressure. . typically I have to hand tighten after I use the air
>wrench. .  but this thing just snapped.
>
>Hard to replace.  . to get the broken one out?  I am tempted to put a bead
>weld on the top of the damn thing and pop the weld off with a big hammer
and
>chisel is I need to ever change the tyre.
>
>Kirk


More information about the Spridgets mailing list