[Spridgets] Venting... a 1275 w/ Weber

WFO Herb froggi60 at gmail.com
Wed Nov 11 17:26:05 MST 2009


Ron,

Wouldn't that 'suck', rather than just 'vent'?

Herb

On Wed, Nov 11, 2009 at 3:41 PM, Ron Soave <soavero at yahoo.com> wrote:

> --- On Wed, 11/11/09, Peter Caldwell <peter at nosimport.com> wrote:
> > How are y'all accomplishing crankcase
> > venting with a side draught Weber on a 1275?
>
> For the intake Cannon manifold, I drilled and tapped a pipe thread where
> the flat is (the spot for Mini brake booster, I think). I did not run a
> balance tube and 1&2 were always a bit lean. I'd add a balance tube if I
> were doing it again. I used a chrysler K-car PCV valve. For Maniflow intake,
> I'm not using one (successfully) but I'd weld in a cross tube with a hose
> barb to go to a PCV valve.


More information about the Spridgets mailing list