[Spridgets] Brake Master Cylinder
Gerard Chateauvieux
pixelsmith at gerardsgarage.com
Wed Feb 18 12:37:32 MST 2009
That's actually incorrect Glen.
A residual valve should not be used with disc brakes. There is a
different valve used with the disc brake kits.
see: http://brakecylinder.com/images/LockheedSprings.jpg
The plastic valve on the right are the ones that should be used. This
is more of a "retarding valve" rather than a residual valve. The
metal cup style on the left needs to have the rubber insert left out.
I suppose your hole in the rubber cup could serve the same purpose,
but I would be concerned that before long, that hole will become
easily obstructed with debris.
In addition, it is also necessary to do something different when
using the disc brake conversion on the Morris Minor. Separate
external residual valves should be used for front and rear because of
the position of the master cylinder. With the master cylinder being
lower than the calipers, you need to prevent fluid drain-back by
using a 2 lb residual valve in the main line to the front branch. I
use a 10lb residual valve to the rear drums.
Gerard
> Message: 6
> Date: Wed, 18 Feb 2009 08:52:59 -0800
> From: "Glen Byrns" <grbyrns at ucdavis.edu>
> Subject: Re: [Spridgets] Brake Master Cylinder
> To: "Spridgets" <spridgets at autox.team.net>
> Message-ID: <FF568384924E4C56AE1B2FFD9DAB8E31 at vgl.cvg.ucdavis.edu>
> Content-Type: text/plain; format=flowed; charset="iso-8859-1";
> reply-type=original
>
> Its for retaining a bit of residual pressure so the brake shoe return
> springs don't fully retract the shoes causing you to have to pump
> up to get
> brake action each time. Its also helps for solo bleeding.
> HOWEVER!!! It
> has less function in a disc brake car and will cause the front
> discs to
> constantly rub a bit too much and wear out the pads pretty fast.
> Disc brake
> conversions require you to punch a small hole in the rubber cup to
> mitigate
> the effect.
>
> Glen
More information about the Spridgets
mailing list