[Spridgets] Ebay Lower Control Arms

[Mark Haynes]

Nope, not the welds (hopefully)- The weak link is the 1/2"-20 Threads! think
about it- ~375lbs (750 lbs/2 joints) in shear on an extended shaft with a root
diameter of 7/16" (being generous), so at rest there's a shear force of 857
lbs (no problem). Then hit a bump/chuck hole, etc. realizing that the shear
strength is ~40% of tensile (again conservative), assuming an impulse of at
least 1/4 the weight of the car and driver(~400lbs)/5 milliseconds gives an
instantaneous loading of 8375lbs. Average yield strength of Grade 2 bolts (and
low end heim joints) is 36ksi. multiply by .4375 for cross sectional area,
again by .4 for shear loading, and it yields at 6773 lbs. That calc is rough,
and not even taking into consideration the horizontal loading (which is much
greater due to the mass of the vehicle).
I'd not drive on such a thing, remember what happened to Flounder with Red Rat
Bastard at speed when he broke a stub axle? Thankfully, he was wearing a
helmet-I don't on the street, do you?

Mark Haynes
HAN6L12779
HAN5L8016

____________________________________________________________
Save on Financial Career Training. Click here.
http://thirdpartyoffers.netzero.net/TGL2231/fc/PnY6rc20AmFiGkZAwPVmL5dBMHbm95
UpSsaRAkdtJyyDCdeBzacSw/