[Spridgets] aiming headlights

[Frank Clarici]

Phil Nase wrote:
> Any rules of thumb for aiming headlights to get them at least close to 
> correct before I take it out for a nighttime spin?
>
> Also, the bugeye bonnet lock handle is held in place by putting a 
> screw in the end and spreading the shaft?  Or is there a pin or 
> something to use?
>
>
I put the car on the street at night, lights on and adjust until they 
look about right, drive around a little to check them out.
Then pull in front of the garage door to see if they are both about the 
same height.

Not sure on the original bonnet handle but when I use a trunk handle, 
it's a bit too long so I put a spring over the square bar and a washer 
under the screw. The spring holds it all from rattling. On the Holy 
Sprite I used a clutch slave cyl spring simply because it was handy and 
it fit.


-- 
Frank Clarici
Toms River, NJ