[Spridgets] HOW THE HELL...

[Dave Yealy]

It takes two people to install it. Find the center of both then mark 
it, then have a person on either end of the rubber and pull apart and 
set it in the groove and each slackens their pull a little till the 
rubber sits in there nice and tight. Brain surgery at it's finest........

Dave


At 03:07 PM 5/4/2008, you wrote:
>Do you get the scuttle seal in?? The one that is where the bonnet meets the
>scuttle, in front of the windscreen.
>I had to cut off about 4", because it was that much longer than my original.
>Now, even after lubing it up with KY, it WILL NOT go in. Since I have cut
>it, I can't return it (what a fucking crock of shit), so I am looking for
>magic ways to get it to fit.
>
>Thanks,
>Brad