[Spridgets] bent frame rails

[Peter Caldwell]

At 02:43 PM 12/19/2008, Trevor Jessie wrote:
>Take a look through these pictures:
>
>http://www.britishv8.org/Articles/BritishMotorHeritage-Midget.htm
===============
That's very cool.  In the 3rd picture, where they are showing the 
1500 engine support, note the toggle clamps. If the bulk of the frame 
is resting on the table, I would estimate the front of the horns to 
be raised about an inch? I'm comparing bolt diameters in the picture.

Also, is the radiator support perpendicular to the frame or do they tilt back?

Peter C