[Spridgets] Crankshaft Spigot bearing removal

Larry Daniels ladaniels at sbcglobal.net
Wed Sep 5 17:03:48 MDT 2007


I just measured one of my ribcases -- 1/2" on the input shaft.

Larry Daniels



----- Original Message ----- 
From: "WJHS1960" <WJHS1960 at comcast.net>
To: <spridgets at autox.team.net>
Sent: Wednesday, September 05, 2007 5:49 PM
Subject: Re: [Spridgets] Crankshaft Spigot bearing removal


<<But wouldn't it be the same as the I.D. of the
aforementioned bearing?>>

Yes Pat, BUT most "shadetree mechanic" situtions do not allow for having a
caliper for measuring something THAT small (5/8" and smaller).  BUT that 
said
a drift should be the same size as the rib-caged tranny input shaft which
Daniel says he does not have.

So the answer he is looking for would be a drift either 11/16s or 5/8s" or
9/16s or 1/2s", I beleive.

I also do not have an input shaft to measure.  Perhaps someone DOES have
either or both handy to measure correctly?!?!?


More information about the Spridgets mailing list