[Spridgets] License Plate Lamp

Jack Laird jlaird237 at cox.net
Tue Jul 17 09:54:03 MDT 2007


No dent, sets on the pannel with a large rubber gasket peice.


----- Original Message ----- 
From: "Timothy H. Collins" <thcollin at mtu.edu>
To: <spridgets at autox.team.net>
Sent: Tuesday, July 17, 2007 8:42 AM
Subject: [Spridgets] License Plate Lamp


> This question pertains to the license plate lamp mounting. I am
> wondering if the lamp assembly just sits on the rear panel following
> the curvature of the entire panel or does it sit in an indentation in
> the rear panel. Mine has a "ripple/dent/?" under lamp mounting and I
> am wondering if it should be there or is that a dent I need to bump
> out. I suspect that it is a dent caused by leaning on the lamp
> assembly at some point in its life.
>
>
> Tim Collins
> _______________________________________________
> jlaird237 at cox.net
>
> Edit your replies
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.476 / Virus Database: 269.10.8/904 - Release Date: 7/16/2007 
> 5:42 PM


More information about the Spridgets mailing list