[Spridgets] Help with clutch problem...
Bob Van Kirk
racerbob70 at yahoo.com
Mon Jul 16 14:06:32 MDT 2007
The clutch throwout bearing is different because of
the different pressure plates. You must use a 1275
T/O on a 1275 pressure plate.......Clutch forks are
the same. If you replaced the T/O bearing perhaps it
was the wrong one.......
--- TMHEFFRON at aol.com wrote:
> In a message dated 7/16/2007 10:53:20 AM Central
> Daylight Time,
> dbl at chicagolandmgclub.com writes:
>
> Anyone know the normal travel range of the slave
> >> piston?
>
> > 5/8 to 3/4 inch.......
>
> So it sounds as if the travel of the piston is in
> the right range. That
> would leave slop in the pivot, bent arm, wrong arm
> for the application,
> bad/worn throwout, defective cover, and other worn
> parts as logical
> suspects.
>
>
>
> Hi David:
>
> Pressure plate - clutch disc and TO bearing are all
> new - didn't seem to be
> any slop in the pivot - this is the same
> transmission that was working just
> fine with 1098 clutch setup - do you need to change
> pivot arm for change to
> 1275 clutch? Would it be worth it to try and take
> almost all the free play out
> at the master? TIA.
>
> TuTone
>
>
____________________________________________________________________________________
Need a vacation? Get great deals
to amazing places on Yahoo! Travel.
http://travel.yahoo.com/
More information about the Spridgets
mailing list