[Spridgets] Rib Case Gear box question AGAIN
Larry Macy
lmacy at phillymgclub.com
Wed Jul 4 04:53:13 MDT 2007
Lining them up is easy. I use a screwdriver and line of sight and get
it right about 90% of the time on first try. Those wooden dowel
thingys you buy are more hassle than they are worth.
I would pull it apart and check since you have the whole thing out
anyway. May want to seriously consider replacing the clutch plate and
throw out bushing/bearing as well. If you don't, you know the whole
thing has to come out again later.
Larry
On Jul 3, 2007, at 2:32 PM, Chris Manuel wrote:
> I never had them apart. I have no problem taking it off, but I have
> no idea
> how to align it back up if I do, even when reading the Bentley
> book. Is it
> tough?
>
> I had an old motorcycle that did this once, but figured this was a
> little
> more involved considering the rear end and all.
>
--
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy at bbl.med.upenn.edu
Senior IT Program Director
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
More information about the Spridgets
mailing list