[Spridgets] Rib Case Gear box question AGAIN

[Jack Laird]

If you did not have the pressure plate off when the tranny was out the 
chances are preaty good.


----- Original Message ----- 
From: "Chris Manuel" <cmanuel at wi.rr.com>
To: "'Spridget Mailing List'" <spridgets at autox.team.net>
Sent: Tuesday, July 03, 2007 12:01 PM
Subject: [Spridgets] Rib Case Gear box question AGAIN


> Hi all-
>
> So I finally got things to line up well.  I think I uncovered another
> problem though...what are the chances of the clutch plates stuck together?
>
> If I spin the engine and move the clutch lever the tail shaft still moves.
>
> Not really a good sign, right?
>
> Chris
> 66 MKIII
> Brookfield, WI
>
>
>> Hi-
>>
>> I'm attempting to reassemble the remote control assembly back to the
>> gearbox, and I just can't seem to get the shaft to mesh up with the forks
>> properly.
>
> This is a twist and hope type of assembly.
> If you step away for a bit and come back to it, it just drops in like
> the book says. I have done it several times, and it always makes me
> wonder. It just does not go no matter what, then after a break, it falls
> into place.
> But you do have to have all the forks in the neutral (lined up) position
> and just twist and wiggle.
>
> -- 
> Frank Clarici
> Toms River, NJ
> _______________________________________________
> _______________________________________________
> jlaird237 at cox.net
>
> Edit your replies
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.476 / Virus Database: 269.9.14/880 - Release Date: 6/29/2007 
> 2:15 PM