[Spits] Size of Crank Pully retaining nut.

[Doug Braun]

I just measured the one on my '72:  It is 1-13/16".

A single socket that large will not be cheap!

I have a monster 18" adjustable wrench, made in China
of course, that I got a couple of years ago at a swap
meet for $15 or so.  It works fine for this
application.  Do you know hte trick of resting the
other end of the wrench on the frame rail, and hitting
the starter to break the nut loose?

Doug Braun
'72 Spit


--- "Smith, Brian (CP)" <BrianSmith1 at templeinland.com>
wrote:

> Listers,
> 
> 
> 
> The subject says it all.  Going to be near a proper
> tool store today and
> would like to buy the correct size first.
> 
> 
> 
> Thanks,
> 
> 
> 
> Brian Smith
> 
> Bogalusa, LA
> 
> **********    Confidentiality Notice    **********
> This electronic transmission and any attached
> documents or other writings
>  are confidential and are for the sole use of the
> intended recipient(s)
> identified above. This message may contain
> information that is privileged,
> confidential or otherwise protected from disclosure
> under applicable law.
> If the receiver of this information is not the
> intended recipient, or the
> employee, or agent responsible for delivering the
> information to the
> intended recipient, you are hereby notified that any
> use, reading,
> dissemination, distribution, copying or storage of
> this information is
> strictly prohibited. If you have received this
> information in error, please
> notify the sender by return email and delete the
> electronic transmission,
> including all attachments from your system.
> _______________________________________________
> 
> Support Team.Net  http://www.team.net/donate.html
> 
> Spitfires at autox.team.net
> http://autox.team.net/mailman/listinfo/spitfires
> 
> http://www.team.net/archive