<div dir="ltr"><div dir="ltr"><div dir="ltr"><div class="gmail_default" style="font-family:verdana,sans-serif">This discussion has been very interesting, because I have struggled with glueing plastics.</div><div class="gmail_default" style="font-family:verdana,sans-serif"><br></div><div class="gmail_default" style="font-family:verdana,sans-serif">However the key point, to me, has not been mentioned: How to identify the <i>type</i> of plastic. Can somebody provide clues?</div><div class="gmail_default" style="font-family:verdana,sans-serif"><br></div><div class="gmail_default" style="font-family:verdana,sans-serif">Another challenging question (for me): What product works well on polyethylene and polypropylene, <i>and</i> has a good shelf life. I have used "Loctite Super Glue All Plastics", which works well but is expensive and has a short shelf life after being opened.</div></div><div class="gmail_default" style="font-family:verdana,sans-serif"><br></div><div class="gmail_default" style="font-family:verdana,sans-serif">Chuck</div><div><br></div><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Wed, Oct 8, 2025 at 11:17 AM <<a href="mailto:shop-talk-request@autox.team.net" target="_blank">shop-talk-request@autox.team.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><br>
Message: 1<br>
Date: Tue, 7 Oct 2025 13:18:30 -0500<br>
From: David Scheidt <<a href="mailto:dmscheidt@gmail.com" target="_blank">dmscheidt@gmail.com</a>><br>
To: Jim Stone <<a href="mailto:1789alpine@gmail.com" target="_blank">1789alpine@gmail.com</a>><br>
Cc: Shop Talk <<a href="mailto:shop-talk@autox.team.net" target="_blank">shop-talk@autox.team.net</a>><br>
Subject: Re: [Shop-talk] Plastic epoxy/solvent weld<br><br>
<span class="gmail_default" style="font-family:verdana,sans-serif">[snip]</span><br>
<br>
Methylene chloride is the traditional solvent for acrylic welding. It is<br>
now banned for most uses, so newer forulmulations use something else. I<br>
have not used any of them, as I don?t work with acrylic. But I did do some<br>
in the mists of time.  There were two types we used.  One was a thin liquid<br>
(straight methylene chloride, or very nearly, I think) that was used for<br>
fabricating stuff with tightly fitted gap free joints.  The other was a gel<br>
that would work for joints with a gap, it had acrylic in it, I think, which<br>
is what gave it gap filling power.  Pick the right sort, based on how well<br>
your parts go back together.<br><br>
<span class="gmail_default" style="font-family:verdana,sans-serif">[snip]</span><br><br>
End of Shop-talk Digest, Vol 19, Issue 151<br>
</blockquote></div></div>
</div>