<div dir="ltr">Fellas,<div><br></div><div>Looking at a used Quincy compressor. The data plate calls it an ATV5. it's a two-stage.</div><div><br></div><div>It runs fine until it reaches about 150 psi, then the belt starts to squeal like the pump is dragging. Does that sound like a common problem?</div><div><br>I figure:</div><div><br></div><div>1) The pistons are expanding, dragging the pump.</div><div><br></div><div>2) The valves aren't closing behind the compressed air, allowing it to 'push back' against the pistons.</div><div><br></div><div>I can't disassemble the thing, but a new pump is almost as much as just buying a new compressor. Any guesses on if I should take a flyer and try to rebuild it?</div><div><br></div><div>Thanks in advance.</div></div>