[Shop-talk] Annealing Copper bars

[Jack Brooks]

Doug,

I tried that with the Norton Jugs.  Mrs. Jack has an incredible nose.  She would know. I’m being upfront.  It’s been discussed.

Jack

From: Shop-talk <shop-talk-bounces at autox.team.net> On Behalf Of old dirtbeard
Sent: Saturday, August 8, 2020 6:43 AM
Cc: shop-talk at autox.team.net
Subject: Re: [Shop-talk] Annealing Copper bars

I sort of like your idea about the self-cleaning oven cycle. It would be very even heat, the right temperature, should not hurt the oven.

Maybe just wait to do it while the wife is away for an hour or so...  :-)

best,

doug

On Sat, Aug 8, 2020 at 5:37 AM Pat Horne <patintexas at icloud.com<mailto:patintexas at icloud.com>> wrote:
Pay a local shop with an oxy/acetylene rig to heat them? Muffler shop, body shop, A/C contractor? A/C contractor sometimes use air/acetylene. Will that get hot enough?

Peace,
Pat
Pat Horne
We support Habitat for Humanity


On Aug 7, 2020, at 11:25 PM, Jack Brooks <JIBrooks at live.com<mailto:JIBrooks at live.com>> wrote:

I have fabricated a number of 1/8 and 3/16th inch thick busbars for an Van RV build electrical system which I am assembling in my shop.  The busbars are already bent to shape, but I’d like to anneal them, because the copper was purchased in the  “Half-Hard” state and making them “Dead-Soft” will insure that they lay completely flat to maximize the conductivity when I final assemble the system.

I usually anneal copper by getting it hot enough to glow with a propane torch and then allow it to cool.  With the mass of these busbars, I can’t get them up to a temperature to where they glow with propane.  An Oxy/Acetylene torch would work, but I don’t have one.  MAPP gas is hotter, but I don’t think it’s a lot hotter.

I am considering running them through the cleaning cycle in the self-cleaning over, as a self-cleaning oven will typically runs up to around 900°F.  Copper needs 700-1,200°F to anneal, so it should be fine.

I’d prefer almost any other solution.  Thoughts?  The last time I used our oven for a shop project, it was to cure the paint on the jugs (cylinders) of my ’74 Norton motorcycle.  Mrs. Jack was not happy.  Copper bars should be fine as they won’t stink up the house.

Thanks in advance,

Jack
_______________________________________________

Shop-talk at autox.team.net<mailto:Shop-talk at autox.team.net>
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/shop-talk/patintexas@icloud.com
_______________________________________________

Shop-talk at autox.team.net<mailto:Shop-talk at autox.team.net>
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/shop-talk/dirtbeard@gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/shop-talk/attachments/20200808/256d5491/attachment-0001.htm>