[Shop-talk] Sticking/Draging caliper

Ian McFetridge shop-talk2 at mcfetridge.org
Tue Jan 5 19:17:28 MST 2016


Is the left-rear caliper the furthest from the master cylinder?  On my
4Runner (2004) this was the first one that would exhibit sticking (I
measured the stickiness by driving around the block and measure the
temperature on each rotor with an IR temp gun).  All the pins, slides, and
eventually the pistons would corrode and drag.  I could take the calipers
apart, sand, wire-wheel, and lubricate to get them to work again (and lower
the relative temperature measured).  OR, I found I could bleed the system
(carefully/well) and get the far caliper to stop sticking for a while--I
think you were going this direction with your logic of a blocked line.
Perhaps, air in the lines doesn't allow enough vacuum to retract the
piston?  Or the bleeding washes out "gunk" (tech term!).

Ymmv,
Ian
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/shop-talk/attachments/20160105/d33eb9dd/attachment.html>


More information about the Shop-talk mailing list