[Shop-talk] Sanding cylinders on drill press

[Doug Braun]

Or rotate the table way off to one side, so the drum can project a bit
below the table.

Doug

On Sat, Feb 16, 2013 at 6:58 PM, Brian Kemp <bk13 at earthlink.net> wrote:

>   Take a piece of thick plywood or a 1x and cut a hole about 1/2" bigger
> than the sanding bit you are using and clamp it to the drill press table.
>  Raise the table so the edge of the bit is below the board with the hole
> and sand away.