[Shop-talk] stripped screw hole in carb

John T. Blair jblair1948 at cox.net
Mon Jun 20 06:13:22 MDT 2011


At 11:10 PM 6/19/2011, BJNoSHOV8 wrote:

 >Is it possible to drill the holes deeper and put threads farther 
into the material?

 >Or 3. Just drill and tap the holes for the next larger bolt if there's enough
 >metal.

Thanks to all that replied.  The consensus seems to be to use the 
helicoil, or go
to the next size up bolt.

Unfortunately, I don't know if there is enough metal there.  This is 
on the outside
lip of the carb, with just a little ear where the bolts are.

At to  going deeper, good idea but won't work as these holes go 
through the metal.  This is an old Zenith carb.

I do like the suggestion about taking it to a small engine repair 
shop and let them
look at it and doing all 5 holes if I do the 3.

I might try that.  The shop may know better than I if there is enough meat left
to go the helicoil route.

While I'm out, I look for either the locktite or Permatex epoxies vis 
just JB Weld.

Thanks again.

John


>_______________________________________________
>
>Shop-talk at autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation  $12.96
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/shop-talk/jblair1948@cox.net

John T. Blair  WA4OHZ     email:  jblair1948 at cox.net
Va. Beach, Va
Phone:  (757) 495-8229

           48 TR1800    48 #4 Midget    65 Morgan 4/4 Series V (B1106)
      75 Bricklin SV1 (#0887)    77 Spitfire    71 Saab Sonett III
                        65 Rambler Classic

Morgan:    www.team.net/www/morgan
Bricklin:  www.bricklin.org

If you can read this             - Thank a teacher!
If you are reading it in English - Thank a Vet!!


More information about the Shop-talk mailing list