[Shop-talk] noid light

Eric J Russell ejrussell at mebtel.net
Thu Oct 28 13:59:10 MDT 2010


To update the dead cylinder/injector/noid light question: it was a faulty 
injector.

The injector's coil measured OK with the ohm meter but it did not inject 
fuel. I never used or tried to make a noid light. I did probe the two 
terminals in the harness connector with the engine running (on 5 cylinders). 
As predicted, it did not show 12V but it did read some small number so I 
assumed electrical signals were reaching the injector. Using a mechanic's 
stethoscope I could easily hear the other injectors clicking with the engine 
idling. But not the #5 cylinder's injector.

I then applied 12V+ & 12V- to the terminals on the injector. No click, no 
life.

Injector replaced (remove intake air ducts, intake plenum with throttle 
body, 2 screws for each injector and lift out the fuel rail. Cut fuel hose 
to free injector then replace with new hose. Re-install all of above) and 
all is well.

Eric Russell
Mebane, NC
http://home.mebtel.net/~ejrussell 


More information about the Shop-talk mailing list