[Shop-talk] Lawn mower engine & blade question
old dirtbeard
dirtbeard at pacbell.net
Fri Jul 16 16:44:17 MDT 2010
Hi Wayne,
It probably is fine, but I would pull the plug wire and pull it though a couple cycles to check for binding. If it pulls though OK, I would attach the plug wire and start it up.
I bet it is fine.
best,
Doug Shook (Blackberry)
323.286.6115
-----Original Message-----
From: Wayne <wmc_st at xxiii.com>
Sender: shop-talk-bounces at autox.team.net
Date: Fri, 16 Jul 2010 17:57:07
To: Shop Talk List<shop-talk at autox.team.net>
Subject: [Shop-talk] Lawn mower engine & blade question
Hi Guys,
I have a simple MTD push lawn mower (that I use to mow around my shop)
with a B&S engine and 22" blade. Today I nailed a small tree stump with
it. Usually you just "graze" things and it somehow survives when you
lift off it. Not this time. The engine stopped instantly. The tip of
the blade, about 3" back, is bent 90 degrees downward!
Is there any chance I damaged the engine? Is it ok to start it with the
blade off, just to see if it runs ok? (don't know if it depends on the
blade as a flywheel, or needs it as a load.)
-Thanks, Wayne
_______________________________________________
Shop-talk at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/shop-talk/dirtbeard@pacbell.net
More information about the Shop-talk
mailing list