[Shop-talk] Head Stud Install

[Chad on LEG]

I'm replacing the head bolts on my SBC with ARP studs.
With the cap screws I used ARP's sealant (the bolts holes
open into the water jacket). I'd like to Loctite the studs in place
but not sure which produce to use. On the mains I used #262 (red)
but #271 "locks and seals (Enco catalog page 917) so I'm thinking this
may be a better choice - the catalog continues "...bearing retaining nuts,
cylinder liner studs, door closer plugs, ..." Any recommendations?
Sure was easier when all they had was "Nutlock" and Studlock"!
Thanks,
chad

-- 

"Our peculiar security is in the possession of a written 
 Constitution. Let us not make it a blank paper by 
 construction."
 -- Thomas Jefferson, letter to Wilson Nicholas, 1803