[Shop-talk] Micrometers

[David C.]

Do you need to measure the diameter of the bore of the engine?  If so, 
then these are all you need:

> http://www.amazon.com/Precision-Telescoping-Bore-Gauge-Set/dp/B00134DPBI/ref=sr_1_3?ie=UTF8&s=automotive&qid=1256780671&sr=8-3



eric at megageek.com wrote:
> OK, it's that time of the year again.  Time to talk about micrometers.
>
> Here is the thing, I found a place that will make the rings for me (Thanks
> to Jack B.)  The problem is, that I need to get a good measurement to send
> him.
>
> So after trying all THREE of my micrometers, I realized that the inside
> and outside of the calipers aren't calibrated.  My most accurate
> micrometer has a fixed one so I can't even adjust it.
>
> So, now, not only do I need a new ring, but I need a new micrometer.
>
> Any suggestions?  I prefer a digital readout one and I'm not looking to
> take a second mortgage out on the house. (hopefully, under $100 bucks if
> possible.)
>
> Thanks!
>
> Moose
> b
Be as beneficent as the sun or the sea, but if your rights as a rational
> being are trenched on, die on the first inch of your territory.b
 Ralph
> Waldo Emerson
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as cavanadd at verizon.net
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive