[Shop-talk] Epoxy recommendations?

[Matt]

Can you drill it and insert a pin?

-- Jim Franklin <jamesf at groupwbench.org> wrote:
My dishwasher has a 1/8" shaft on its main motor that drives the
impeller. The impeller is on a plastic shaft that slides over the
motor's shaft. There are, well, used to be splines to keep these two
parts rotating at the same speed, but after 8 years of Extreme
Dishwashing the plastic splines have worn out and squeals like a stuck
pig (no pig in the DW, I checked).

In frigidaire's infinite bean counting wisdom they made it impossible
to obtain just the wearable plastic shaft; I need to replace the whole
motor. So I'm looking to epoxy the shafts together. Will A + B work?
What if it's about 15 years old? Is there something better than A + B?
It's a high torque application and I can only do this once.

thanks,
jim
You are subscribed as mbarre at juno.com

Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive
____________________________________________________________
Click to consolidate debt and lower month expenses.
http://thirdpartyoffers.juno.com/TGL2141/fc/PnY6rw2PBHPpArG18AsoHLQDPnRIBwhGR
WMSItVyR23vxIvZMp7PQ/