[Shop-talk] Basic MIG Welding questions
Mark Andy
mark at sccaprepared.com
Wed Feb 4 09:03:29 MST 2009
Howdy,
On Mon, 2 Feb 2009, Marc wrote:
> Well, there's a purge setting on the 180, which is basically just a wire
> feed speed of 0. I use the purge setting to set gas flow without wasting
> wire. Maybe you could rig up a switch to open the circuit to the feed
> motor...
My lincoln SP175Plus has a purge setting. You activate it by flipping the
feed roller clamp up.
:-)
Mark
More information about the Shop-talk
mailing list