[Shop-talk] Dishwasher motor (was Epoxy recommendation)
Jim Franklin
jamesf at groupwbench.org
Sun Feb 1 09:32:25 MST 2009
I JB Welded the plasitc sheath onto the motor shaft and that's when I
discovered the hairline crack running down the length of the sheath.
But it held well. However in the process of all that the 2 shouldered
rubber grommet/washer things fell off and I can't figure out how they
go back on. Each orientation leaks. So I bought a new motor from
RepairClinic.com, because they had a page on the problem and fix of my
particular DW.
The old motor is 3 amps and about the size of an econobox starter.
What arrived is a generic, one size fits all motor that clips into a
sump that replaces my DW's sump. The motor is .65 amps and weighs
about 3 oz. It doesn't feel like there's any metal in it at all.
Should I even bother putting it in? I looks like it'd have trouble
powering a goldfish tank. Are looks deceiving, and a motor that draws
1/6 the power can really do the job?
thanks,
jim
More information about the Shop-talk
mailing list