[Shop-talk] water filter for blast cabinet

Marc smarc at smarc.net
Mon May 19 16:58:47 MDT 2008


You know, this filter also makes a pretty efficient CAPACITOR...  
Apparently some of my water evaporated, and after running the thing a 
while, it took in enough glass bead to absorb what little water was 
left, leaving a very thick paste in the bottom. Soooo.... a LOT of 
static was generated, and was  STORED by the filter/capacitor.

So after working for a while I decide check on the filter. I remove the 
lid, reach in to remove the metal baffle plate, and WHAM! It knocks me 
on my arse and causes a mild case of Tourette Syndrome...

I took a jumper cable and tried to discharge it. Drew SEVERAL large 
discharges, even left it there for a bit. It still had plenty of juice. 
I finally had to use a couple foot long wooden dowel with a hook to 
dismantle it.

Yow!

Marc



Marc wrote:
> Thanks to all for some pretty cool ideas. In the end, I went for 
> simplicity and just made a baffle, a) because I could use what I had on 
> hand, and b) because I could get on with what I actually set out to do!
>
> I took some sheet metal,  cut out a circle sized to fit snugly in the 
> bucket, about 1/3 of the way down. Cut a hole for the inlet pipe to pass 
> through, and drilled about a dozen holes in the center.
>
> Success! Just the tiniest dribble of water in the hose to the shop vac, 
> not enough to be concerned with. Upon firing up the vacuum, the first 
> thing I noticed was the gloves were sucked into the cabinet (they 
> usually hang out the front, inside out...) It works fantastically! I can 
> see inside the cabinet, and there was no dust everywhere on everything! 
> The only downside is having to wear ear protection now. However, with 
> enough hose I can put the shop vac outside...


More information about the Shop-talk mailing list