[Shop-talk] dry cut metal saw

john niolon jniolon at bham.rr.com
Wed Jan 9 18:00:50 MST 2008


I don't know if this qualifies as a "tip or trick" or more of a tool 
recommendations.

Back a few months ago a member of the Ford site I frequent  told me about a 
dry cut metal saw blade that could replace an abrasive blade in a chop saw. 
They can handle the chop saw speed. They are made by Bullet Industries.  The 
14" model (chop saw size) is about 50 bucks.  I ordered and finally got to 
install tonight.

clamped in a piece of 2x2x<" angle iron and dropped the blade down.. It 
almost fell thru the metal !!!  If you've used a chop saw you know about 
pressure on the blade and the mess it makes.  Only the lightest pressure is 
needed...just let the blade do the work.  It's like a hot knife thru soft 
butter..  The output was very fine chips of metal that pretty much stay 
close to where you're cutting and not floating around in the air and up your 
nose like the abrasive dust.

I can't say anything about longevity yet, but for speed of cut and ease of 
cut this is the best I've found... check them out below.  If you do a lot of 
fabricating and cutting... this really seems like the way to go....


http://www.bulletindustries.com/catalog/product_info.php/cPath/99_144/products_id/784

john

All I ask is a chance to prove that money can't make me happy. 


More information about the Shop-talk mailing list