[Oletrucks] New Gas Gauge Problems SECONDING SENDING

James Hays thomasind at nventure.com
Thu Sep 1 19:11:31 MDT 2011


AS MOST MEN - RECHECKED INSTRUCTIONS ON NEW SENDER / GAUGE - USED TABLE 2,
NOT TABLE 1 ( INSTRUCTIONS FOR TWO SENDERS INDICATED ) FOR INSIDE TANK ARM
ADJUSTMENT THAT SHOULD LAY THE FLOAT ON THE BOTTOM OF THE TANK.

IF THIS IS THE PROBLEM THINKING ALL ELECTRICAL OFF ALL TRUCK & BUILDING -
QUICKLY COVER HOLE WITH DUCT TAPE WITH 1/4 TANK OF GAS ?

THANKS,
JIM



-----Original Message-----
From: oletrucks-bounces at autox.team.net
[mailto:oletrucks-bounces at autox.team.net] On Behalf Of James Hays
Sent: Thursday, September 01, 2011 5:40 PM
To: oletrucks at autox.team.net
Subject: [Oletrucks] New Gas Gauge Problems

Ole Wise List:     New 4 cluster gas gauge will not register - other 3
gauges work.  Removed  sender wire at the sender - no effect on the gauge (
maybe minus a small needle movement ) - grounded unconnected sender wire (
good ground from sender cover to ground ) & gauge registers over full ?

 

Any suggestions appreciated,

Jim

55-1st  5 window


More information about the Oletrucks mailing list