[Oletrucks] Recommendation for replacement of driveshaft and rear axle for '52 GMC 1/2 ton
james hays
thomasind at nventure.com
Mon Nov 30 00:37:54 MST 2009
Jerry:
Think it would be more cost effective to go used another rear end & drive
shaft. I had a 75 rear end re-bearinged and possi installed by local
moonlighter for $600.
I picked up a good used drive shaft (think Ford ) from a junk yard for $35
the correct length ( measured center of u-joints ) and had NAPA install
u-joints to agree with my 4L60E trans & GM 12 bolt rearend for $75
- they make all kinds of u-joint designs to agree with unusual fits as long
as you know what ends you need.
Jim
55-1st P U
----- Original Message -----
From: "Jerry and Phyllis Charles" <jpchas at att.net>
To: <oletrucks at autox.team.net>
Sent: Sunday, November 29, 2009 3:49 PM
Subject: [Oletrucks] Recommendation for replacement of driveshaft and rear
axle for '52 GMC 1/2 ton
>I need some recommendations for the replacement of the enclosed driveshaft
> and 411 rear differential. Should I replace the ring gear with 3.55, new
> bearings, and new driveshaft components or should I replace the rear axle
> and driveshaft with something newer? What would be cheaper and more
> reliable?
>
>
>
> Jerry Charles
More information about the Oletrucks
mailing list