[Oletrucks] Ignition switch question

[Bob]

There Should be a wire from the switch on the top of the starter to a  
terminal on the ignition switch and one from another terminal to the  
ballast resistor. The other end of the ballast resistor is connected  
To the coil
Bob
Sent from my iPhone

On Nov 27, 2009, at 7:42 PM, "Charles Culver" <smokey at railops.com>  
wrote:

> I need a little help with an electrical problem.  Accidentally  
> pulled some
> wires loose while replacing a speedometer cable on the '50 3600, and  
> now I
> am not getting fire when I try to start the engine.  My "ignition  
> switch"
> has a terminal for the battery and one for accessories.  I do not  
> use the
> ignition terminal because the starter pedal is on the floor.
>
>
>
> So I have 2 ignition switch terminals to hook up wires to so that  
> when I
> turn on the key a circuit is closed and I get fire when I start the  
> engine.
> One terminal has a hot wire from the battery.  That one is hooked  
> up.  The
> other one has accessories such as blinkers, gas gauge, radio etc.   
> They all
> work when I turn the key on.  I am not sure where the missing wire  
> comes
> from, but I would think from the distributor or coil (?).
>
>
>
> Thanks for your help!
>
>
>
> Smokey
>
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> http://www.team.net/archive
>
> Oletrucks at autox.team.net
>
> http://autox.team.net/mailman/listinfo/oletrucks
>
> You are subscribed as kinderlehrer at comcast.net