[Morris] Throwout bearings redux

[Michael Marr]

I am still lurking but don't have much to contribute since I haven't owned a 
Morris since 1972.  I have half an eye open for a Minor, however.

Mike

--------------------------------------------------
From: "Gerard" <pixelsmith at gerardsgarage.com>
Sent: Thursday, March 01, 2012 12:36 AM
To: "Kevin Wayne Williams" <kww at kwwilliams.com>
Cc: "Morris Motors" <morris_motors at yahoogroups.com>; "Morris" 
<morris at autox.team.net>
Subject: Re: [Morris] Throwout bearings redux

> Not sure there are any active members on the autoX Morris list anymore.
>
> See my web page.
>
> http://gerardsgarage.com/Garage/Tech/TO_Bearings/tobearings.htm
>
> Gerard
>
> On Feb 29, 2012, at 5:37 AM, Kevin Wayne Williams wrote:
>
>> Well, my new, roll-pin free 1275 throwout bearing arrived, and it's  at 
>> least a 1/4" taller than my other 1275 throwout bearings.  Obviously, one 
>> or more of these bearings is not a 1275 throwout  bearing.
>>
>> Does anyone know the exact measurement points to distinguish 1098  from 
>> 1275 bearings? I know 1275s are taller, but for all I know this  bearing 
>> is from a Yugo or something, so I don't want to just blindly  install the 
>> tallest of the set.
>>
>> KWW
>> _______________________________________________
>>
>> Morris at autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation  $11.47
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage: 
>> http://autox.team.net/mailman/options/morris/pixelsmith@gerardsgarage.com
> _______________________________________________
>
> Morris at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/morris/mmarr@notwires.com