<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META content="text/html; charset=utf-8" http-equiv=Content-Type>
<META name=GENERATOR content="MSHTML 8.00.6001.23588">
<STYLE></STYLE>
</HEAD>
<BODY dir=ltr bgColor=#ffffff>
<DIV><FONT size=2>Flasher? W1, C1 and C2 are the terminals on a
particular Lucas relay used as the electric fan relay for the GT V8, for
example, but were used for other things on a number of other British makes and
marques. They are rectangular.</FONT></DIV>
<DIV><FONT size=2></FONT><FONT size=2></FONT> </DIV>
<DIV><FONT size=2>Are you sure the flasher unit (strictly speaking it's not
a relay) goes behind the console? It did on some cars, but on others
it was behind the dash pushed into a clip screwed to the bulkhead. 2-pin
are rectangular but smaller than the relays, 3-pin may be cylindrical and quite
a bit larger. I'm not aware of a relay inside the cabin on any MGB,
maybe someone in the past went to replace the flasher unit but asked for a relay
instead.</FONT></DIV>
<DIV><FONT size=2></FONT> </DIV>
<DIV><FONT size=2>The wire colours should be brown to the X terminal on the
flasher unit, light-green/brown to L to light the lamps at the corners of the
car via the hazard switch, and light-green/purple on P for the tell-tale on the
console. Also the brown comes via an in-line fuse (brown both sides) which
should be near the flasher unit and is shown as connecting directly to it, no
bullet connector on the flasher unit side although there is a 2-way connector on
the supply side.</FONT></DIV>
<DIV><FONT size=2></FONT> </DIV>
<DIV><FONT size=2>Problems with some lights flashing and some not, and the
indicators not working, are usually down to the hazard switch itself. On
most cars it is very rarely used and the grease hardens over time to become an
insulator rather than a lubricant. Sometimes flipping the switch back and
fore a few times will get it going again, but I've had to dismantle the switch,
clean out the old grease and use fresh before it worked
consistently</FONT></DIV>
<DIV><FONT size=2></FONT> </DIV>
<DIV><FONT size=2>PaulH.</FONT></DIV>
<BLOCKQUOTE
style="BORDER-LEFT: #000000 2px solid; PADDING-LEFT: 5px; PADDING-RIGHT: 0px; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px">
<DIV style="FONT: 10pt arial">----- Original Message ----- </DIV>
<DIV><FONT size=2></FONT><BR></DIV>
<DIV dir=ltr>
<DIV style="FONT-FAMILY: 'Calibri'; COLOR: #000000; FONT-SIZE: 12pt">
<DIV>Doing some minor things this morning, needed to fix the Hazards and went
to replace the hazards flasher. </DIV></DIV></DIV></BLOCKQUOTE></BODY></HTML>