[Mgs] Instrument Retainer

[Richard Lindsay]

Same here, Paul. The metal bit is just a cut, drill and a couple of bends.
The nut, which is out of sight, out of mind, can be just a hex nut or, as I
have done, chuck a correct size screw in the drill, with the subject-hex
nut threaded on, then spin the nut against the spinning grinder until
'most' of the hex 'corners' are rounded down. I used a brass nut.

Yes, that is a solution, not a 'correct' solution.

Wait! You said 'speedo'! The nut is the same but the bracket is intricate.
Hummm...

Rick

On Tue, Feb 11, 2020, 2:16 AM PaulHunt73 via Mgs <mgs at autox.team.net> wrote:

> I've had to make one in the past, not too difficult.
>
> ----- Original Message -----
>
> Anyone have a single instrument dashboard retainer and round nut to hold
> my speedo in place?
>
> _______________________________________________
>
> Mgs at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/mgs http://autox.team.net/archive
>
> Unsubscribe:
> http://autox.team.net/mailman/options/mgs/richardolindsay@gmail.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/mgs/attachments/20200211/78743467/attachment.htm>