[Mgs] engine

[Barney Gaylord]

Well, for MGA:

HBZ0615 - for early cars
3/8-24-UNF x 1-7/8 long

ACH8483 - Com. (C) 21513
3/8-16-UNC x 1-7/8 long

For MGB I might "guess" the later part carries over from MGA, but I 
don't have a SPL for the MGB to verify it.

Barney Gaylord
1958 MGA with an attitude
http:/MGAguru.com


At 08:24 PM 7/19/2010 -0300, Malcolm Jeffcock wrote:
>....
>Can anyone tell me the size/thread of the two bolts which hold in 
>the clutch slave cylinders? ....
>
>As well any directions on the wiring for the o/d? I had tape on them 
>reconnected them first but took no notice and they have come off, 
>perhaps a cat perhaps just with jiggling engine trying to get on the 
>engine mounts, doesn't matter and I should have left tape on them but didn't...
>....
>Malcolm--hoping to drive his MG this weekend!