[Mgs] Voltage stabiliser

[Barrie Robinson]

As a result of reading "How to replace your MGB's Thermal Voltage 
Stabiliser" from the British V8 Magazine, I delved into the subject - 
well, I had no beer, there was snow on the ground, the Maserati would 
not start, the jet was being serviced........and my butler and cook 
had the day off, so can you blame me?

It would seem that the circuit as described in the article is a bit 
short and would be subject to erratic behaviour under certain 
circumstances.  My circuit has double bypass filters using both 
electrolytic and ceramic capacitors.  The components are so damn 
cheap so overkill is not a problem.   However, I have to make a unit 
to fit inside the original casing and I do not have a spare close 
by.  Can anyone give me the inside dimensions of the casing 
please?.  Or, if anyone has a dud one I would gladly give you a 
couple of dollars, plus postage, for it.

Regards
Barrie

Barrie Robinson
(705) 721-9060
http://www.britishv8.org/MG/BarrieRobinson.htm
http://www.britcot.com