[Mgs] head question
Eric
eric at erickson.on.net
Fri Nov 14 22:14:46 MST 2008
On 15/11/2008, at 12:53 PM, Malcolm Jeffcock wrote:
> The head from the "donor engine" a 3 bearing older engine has a
> marking on the under side sort where the thermostat bulge is
> located. It has an "S" in a raised letter in the same fashion as the
> MOWOG lettering.
I am sure you can use Google as well as I can, but I noticed I had
this page bookmarked:
Identifying MGB Cylinder Heads
http://www.flowspeed.com/cylinder-ident.htm
Eric
More information about the Mgs
mailing list