[Mgs] windows assembly

[Paul Hunt]

If by 'furry stuff' you mean the stuff that goes in the glass guides then it 
is probably easier to put that in the channels before fitting the channels 
to the door.  But without being facetious I think it would be pretty tricky 
putting the channels in the doors after the glass.  From there it is a case 
of bit by bit - you can't fully tighten the channels until you have the 
glass fully in to get the correct width, but if they are too loose the glass 
could jump out of one or other of the channels while you are inserting it. 
The most important part concerns the alignment of the 1/4-light/vent frame 
with the windscreen - the top of the frame must not be tight up against the 
screen seal or scuttle shake will cause the 'crack of doom' in the door 
skin.

PaulH.

----- Original Message ----- 
> is there a preferred order to put the vent frame, window glass, and furry
> stuff back in on the doors?