[Mgb-v8] Voltage stabiliser

[Jim]

Barrie: the filter caps are not needed. A noisy circuit is ok in this applacation. The gauges don't care.

Jim Miller

Sent from my iPod

On Nov 28, 2008, at 4:26 PM, Barrie Robinson <barrie at look.ca> wrote:

As a result of reading "How to replace your MGB's Thermal Voltage Stabiliser" from the British V8 Magazine, I delved into the subject - well, I had no beer, there was snow on the ground, the Maserati would not start, the jet was being serviced........and my butler and cook had the day off, so can you blame me?

It would seem that the circuit as described in the article is a bit short and would be subject to erratic behaviour under certain circumstances.  My circuit has double bypass filters using both electrolytic and ceramic capacitors.  The components are so damn cheap so overkill is not a problem.   However, I have to make a unit to fit inside the original casing and I do not have a spare close by.  Can anyone give me the inside dimensions of the casing please?.  Or, if anyone has a dud one I would gladly give you a couple of dollars, plus postage, for it.

Regards
Barrie

Barrie Robinson
(705) 721-9060
http://www.britishv8.org/MG/BarrieRobinson.htm
http://www.britcot.com  _______________________________________________
Support Team.Net  http://www.team.net/donate.html

Mgb-v8 mailing list

You are subscribed as v8mgb at yahoo.com

Mgb-v8 at autox.team.net
http://autox.team.net/mailman/listinfo/mgb-v8