[Mg-t] Question

[Lawrie Alexander]

Known as a "blanket bar", Gene, perhaps on some cars it was a place to hang 
the blanket that was needed to keep passengers' legs warm in pre-heater 
days.  However, on the TD its function was to support the front of the 
half-tonneau cover, which tucked over it then had elastic straps leading 
down to studs on the back of the seat near the bottom.

Lawrie
----- Original Message ----- 
From: "Gene Fodor" <crownwheel at surfglobal.net>
To: <mg-t at autox.team.net>
Sent: Tuesday, November 10, 2009 7:48 AM
Subject: [Mg-t] Question


> Good Day Listers . on the TD's seat back, there is a bar that runs the 
> width
> of the back. It is attached to the back by 4 screws - 2 on each side of 
> the
> bar.
>
> It does seem to have any specific purpose as the tilt of the back is
> adjusted by another assembly located immediately below the bar.
>
> This is kind of a trivial question, but does anyone know it purpose?
>
> Tks
>
> Cheers
>
> Gene
>
> Vermont
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Mg-t at autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive