[Mg-t] Temp gauge kaput

[John Seim]

APT Instruments (Charles)	
9632 Humbolt Ave. So.
Bloomington, MN 55431	
952-881-7095

MO-MA			
1321 2nd St. N.W.	
Albuquerque, N.M.		
505-766-6661
momanm at qwest.net

Nisonger Instrument		
570 Mamaroneck Ave.
Mamaroneck, N.Y.		
914-381-1952

West Valley Instruments	
19314 Van Owen Blvd.
Reseda, CA 91335		
818-758-9500

Vintage Restorations - John Marks	
The Old Bakery, Windmill Street,
Turnbridge Wells, Kent,
England TN2 4UU			
011-44-1892-525899
instruments at vintagerestorations.com

You could just plug off the opening. It is 3/8" british standard pipe 
parallel.
Or, a MGB combo gauge will work.

John Seim
Irvine, CA

On Jun 29, 2008, at 5:58 PM, Mike Eldred wrote:

> The temp gauge in my 1954 TF 1250 isn't working - I know I'll have to 
> send it
> out to be repaired, but does anyone have any thoughts on a temporary 
> guage
> solution?  I don't want to have to deadline it while the gauge is out. 
>  I was
> thinking of getting an aftermarket electrical gauge and sending unit 
> for a
> temporary setup, but I'm not sure what might fit.
>
> Also, any recommendations on where to send the original unit for 
> repair?
>
> Cheers,
> -Mike Eldred
> Wilmington, VT
>
> _________________________________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Mg-t at autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive