[Land-speed] Scatter shield question

[J.D. Tone]

I think you answered your own question. If you make it, it must be a minimum 
of 1/4" thick. If the one you are willing to redrill to fit your block meets 
the SFI spec then it still will after you redrill it. I've never measured 
the thickness of a Lakewood, McCleod or any other "can". In my experience 
most SFI bellhousings just a sticker on them.. Good Luck
----- Original Message ----- 



> If a shield is aftermarket and fulfills the SFI 6.1 we are good to go. 
> The
> shield is definitely aftermarket,
> but is 0.232 thick.  It appears to be hydro-formed.  Should I expect to 
> find
> any markings on it somewhere
   The rulebook, as
> I interpret it, says that if a shield must be
> fabricated, it must be 0.252 thick.