[Land-speed] Heat Protection

[drmayf]

Guys, thanks for all the possible solutions. I think I have one that is 
good enough. I am just gonna fold over a piece of header wrap material, 
have the crew chief sew it closed on the open side, slide my tubing into 
it and be done with it.

Many thanks,

mayf
Benn wrote:

> I don't think that foam stuff for pipes is gonna have sufficient 
> high-temp and radiation resistance--might even be rather flamable.  
> I'd guess the subject lines go near the exhaust, perhaps?  You then 
> need radiation shielding as much as or more than insulation.  So I'd 
> be thinking metal (with some sort of liner/spacer just to keep the 
> metal out of contact with the line).
> Benn
>
> ----- Original Message ----- From: "Elon" <saltfever at comcast.net>
> To: "land-speed submit" <land-speed at autox.team.net>
> Sent: Saturday, February 21, 2009 4:46 PM
> Subject: [Land-speed] Heat Protection
>
>
>> Local hardware store for the stuff used to keep your water pipes from
>> freezing. Or lay it in a tray and pour the 2-part foam in a can used for
>> home insulation if a rigid line is ok.
>>
>>
>>
>> From: drmayf
>>
>> . . . My water injection line is 1/4 od high quality air line. I 
>> would like
>> some suggestions for sliding something over it to gie it some heat
>> protection.
>
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as drmayf at mayfco.com
>
> http://autox.team.net/mailman/listinfo/land-speed