<div dir="auto">67 BJ8<div dir="auto">Approx 15k mi on rebuilt engine by PO.</div><div dir="auto">Recently detected water droplets and creamy oil residue inside valve cover and near oil filler.</div><div dir="auto">Pains as engine and car run so well ... grr</div><div dir="auto">Did compression test and all OK at around 150 psi</div><div dir="auto">Also had oil analysis done that confirmed glycol in oil. Interesting no water found ... assume gets burnt off ?</div><div dir="auto">Upon reflection realise had been losing some coolant. Have recently installed a recovery reservoir and attributed the loss to air being removed. Silly me.</div><div dir="auto">So need some ideas how to proceed and if there is a likely culprit area  that others may have encountered ?</div><div dir="auto"> Maybe start by re torqueing the head ?</div><div dir="auto">Not sure how to retest though apart from another oil test.</div><div dir="auto">Remove head ?</div><div dir="auto">Thoughts and ideas please</div><div dir="auto">rg</div><div dir="auto"><br></div></div>