<html><body>Ok, as long as we are showing clamps, here is my NOS exhaust bracket set. It was still wrapped in this photo, but as Curt says- its British thread-probably until mid 1954 when they tried to unify or whenever the bin holding exhaust brackets ran out and they refilled it. Whichever came first. They did not throw any away in lieu of unified replacements. <div><br></div><div>Likely, Michael's new set will be UNF as they are not making any early parts for "purists"-same holds true on the rear gearbox mounts and other items as well. Hank<br><br><div class="reply-new-signature"></div><p>-----------------------------------------</p>From: "Curtis Arndt via Healeys" <healeys@autox.team.net><br>To: "Michael Salter"<br>Cc: "Ahealey help"<br>Sent: Tuesday May 23 2023 8:27:22AM<br>Subject: Re: [Healeys] Exhaust hangers<br><br>
<div dir="ltr">
<div dir="ltr"><font size="4"><i><To be correct the "U" clamp
should have UNF threads. Just
sayin'></i><br></font></div>
<div dir="ltr"><font size="4"><br></font></div>
<div dir="ltr"><font size="4">Michael, FWIW, both of my ORIGINAL
"U" shaped clamps have BSF fasteners... See photos. I reused one of
my originals when I restored my BN1. Modern reproduction "U"
clamps use UNF or more commonly UNC fasteners.</font></div>
<br><div class="gmail_quote">
<div dir="ltr" class="gmail_attr">On Mon, May 22, 2023 at 7:33 PM
Michael Salter <<a>michaelsalter@gmail.com</a>>
wrote:<br></div>
<blockquote class="gmail_quote" style="margin:0px 0px 0px .8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex;">
<div>The strut attaches to an extra length oil pan
screw, the one directly below the spot where the tach cable
attaches to the tach drive housing.
<div>To be correct the "U" clamp should have UNF
threads. Just sayin'</div>
<div><br></div>
<div>M</div>
</div>
<br><div class="gmail_quote">
<div dir="ltr" class="gmail_attr">On Mon., May 22, 2023, 5:47 p.m.
Michael MacLean via Healeys, <<a>healeys@autox.team.net</a>> wrote:<br></div>
<blockquote class="gmail_quote" style="margin:0px 0px 0px .8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex;">
<div dir="ltr">
<div>Excuse my ignorance, but can someone tell me what number 8 is
bolted to and where does it clamp to the exhaust pipe? Anyone have
a picture of this hanger in place? I am ordering all the
hangers for the exhaust system to install before I take the car off
the jack stands.</div>
<div>Mike MacLean</div>
</div>
</blockquote>
</div>
</blockquote>
</div>
</div>
</healeys@autox.team.net></div></body></html>