<div style="color:black;font: 12pt Comic Sans MS, sans-serif;">Simon,
<div>You seem to be close to a water tight seal if you only have one leak & it took 10 minutes to get inside.</div>
<div>I would consider replacing the seal you made out of an inner tube. That rubber is not very compressible. Try to find a thin (like the inner tube rubber) & spongy rubber strip.</div>
<div>Gary Hodson<br>
<br>
<div style="font-family:arial,helvetica;font-size:10pt;color:black"><font size="2">-----Original Message-----<br>
From: m.g.sharp--- via Healeys <healeys@autox.team.net><br>
To: simon.lachlan@alexarevel.plus.com; 'Healeys' <healeys@autox.team.net><br>
Sent: Fri, Apr 28, 2023 9:01 am<br>
Subject: Re: [Healeys] Slight leak at hood<br>
<br>
<div id="yiv4688890401"><style><!--
#yiv4688890401 filtered {}
#yiv4688890401 filtered {}
#yiv4688890401 p.yiv4688890401MsoNormal, #yiv4688890401 li.yiv4688890401MsoNormal, #yiv4688890401 div.yiv4688890401MsoNormal
{margin:0cm;font-size:11.0pt;font-family:"Calibri", sans-serif;}
#yiv4688890401 span.yiv4688890401EmailStyle19
{font-family:"Calibri", sans-serif;color:windowtext;}
#yiv4688890401 .yiv4688890401MsoChpDefault
{font-size:10.0pt;}
#yiv4688890401 filtered {}
#yiv4688890401 div.yiv4688890401WordSection1
{}
--></style>
<div>
<div class="yiv4688890401WordSection1">
<div class="yiv4688890401MsoNormal">Simon, there should be a rubber seal along the bottom of the top bow that seals it against the chrome strip of the windscreen frame. I recently had a new top installed, but I looked after the seal. I am not sure what the original seal looked like, so I got a couple of candidate replacements from a local English Car trimmer and experimented. It is tricky, as I found that most of the seal profiles made is very hard to get the top bow on and clamped down, but I eventually found a thin, rectangular section seal that worked. I have yet to test in the rain, but I have high expectations.</div>
<div class="yiv4688890401MsoNormal"> </div>
<div class="yiv4688890401MsoNormal">Also, make sure the leak is between the top bow and the frame, not between the frame and the glass. As tops age they shrink slightly and get very tight and when up can pull the top frame right off the windshield. I was horrified some years ago when I put my old top up, got in the car, and could see daylight between the glass and the frame! I took the windshield out, took it apart and re-assembled with new sealing around the windshield glass (actually Rich Chrysler did it for me – it is a tricky job).</div>
<div class="yiv4688890401MsoNormal"> </div>
<div class="yiv4688890401MsoNormal">Good luck.</div>
<div class="yiv4688890401MsoNormal"> </div>
<div id="yiv4688890401yqt62972" class="yiv4688890401yqt2108601960">
<div>
<div style="border:none;border-top:solid #E1E1E1 1.0pt;padding:3.0pt 0cm 0cm 0cm;">
<div class="yiv4688890401MsoNormal"><b><span lang="EN-US" style="">From:</span></b><span lang="EN-US" style=""> Healeys <healeys-bounces@autox.team.net> <b>On Behalf Of </b>Simon Lachlan via Healeys<br clear="none"><b>Sent:</b> April 28, 2023 8:18 AM<br clear="none"><b>To:</b> 'Healeys' <healeys@autox.team.net><br clear="none"><b>Subject:</b> [Healeys] Slight leak at hood</span></div>
</div>
</div>
<div class="yiv4688890401MsoNormal"> </div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">I was driving home the other night in my BT7 when it started to rain…nothing much, a heavy drizzle.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">No great worries….I try to avoid rain, but it’s more or less inevitable in SW UK.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">But what was irritating was that it started to leak after about 10 minutes. Not a lot, but it would probably have been much worse if the rain had been much heavier.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">It was only in one spot…running down the windscreen right in my direct line of sight. Typical.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">I’m sure this is a regular occurrence; they were probably issued with leaks at the factory.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">How have you guys fixed(?) this? I thought that I had..I cut up an old inner tube and stuck that to the mating surface of the bow. Now I wonder whether I should put another piece in where it leaked or would that create a little raised section and that it would now leak on either side of that….?</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">In the past, anticipating a long drive in the rain, I’ve taped it up. Works a treat.</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">Thanks,</span></div>
<div class="yiv4688890401MsoNormal"><span lang="EN-GB">Simon </span></div>
</div>
</div>
</div>
</div>
<div class="yqt2108601960" id="yqt99574">_______________________________________________<br clear="none">Support Team.Net <a shape="rect" href="http://www.team.net/donate.html" target="_blank">http://www.team.net/donate.html</a><br clear="none">Suggested annual donation $12.75<br clear="none"><br clear="none">Archive: <a shape="rect" href="http://www.team.net/pipermail/healeys" target="_blank">http://www.team.net/pipermail/healeys</a> <a shape="rect" href="http://autox.team.net/archive/healeys" target="_blank">http://autox.team.net/archive/healeys</a><br clear="none"><br clear="none"><a shape="rect" ymailto="mailto:Healeys@autox.team.net" href="mailto:Healeys@autox.team.net">Healeys@autox.team.net</a><br clear="none"><a shape="rect" href="http://autox.team.net/mailman/listinfo/healeys" target="_blank">http://autox.team.net/mailman/listinfo/healeys</a><br clear="none"><br clear="none">Unsubscribe/Manage: <a shape="rect" href="http://autox.team.net/mailman/options/healeys/warthodson@aol.com" target="_blank">http://autox.team.net/mailman/options/healeys/warthodson@aol.com</a><br clear="none"><br clear="none"></div>
</font></div>
</div>
</div>