<div dir="ltr"><div>Trying to install the wiper rack and motor back into the BN2.  I find the spindle nearest the wiper motor is just short of the hole in the shroud.  Not sure if it fit before the shroud was removed and put back on because the rack and motor was given to me as a used setup for the 100 complete.  At least I think it is for a 100.  Anyone tell me what a BN2 wiper motor looks like?  The distance between the two spindles is correct.  When I put the spindles in place in the two holes in the shroud the rack does not reach the wiper motor by 1/4 to 1/2 inch.  I bought a complete new rack with spindles from the UK, but the tubing that connects to the wiper motor is a straight piece of tubing, not curved like the original one.  I have not compared it to the original curved one for length, but I suspect it is short also.  Short of trying to make one myself, are there any vendors that custom make the tubing in different lengths for the wiper rack?</div><div>Mike MacLean<br></div></div>