<html>
<head>
<meta http-equiv="Content-Type" content="text/html; charset=UTF-8">
</head>
<body>
I started with the BCS kit, so I have the sealing washer on the
dipstick, and I put a screw in the hole in the oil filler cap (I
didn't think solder would stick on the oily cap, and I wanted
'reversible' at the time). At idle, you can feel a vacuum if you put
the palm of your hand over the oil filler hole (haven't tried it on
the highway).<br>
<br>
<br>
<div class="moz-cite-prefix">On 3/21/2022 10:43 PM, i erbs wrote:<br>
</div>
<blockquote type="cite"
cite="mid:CABXhz88f6wLW4=YjSA8rSJ3oHSVR1zLWO0Kq+SxVCfa2_VV1eg@mail.gmail.com">
<meta http-equiv="content-type" content="text/html; charset=UTF-8">
<div dir="auto">Did you do anything else? Just ran the pvc to the
manifold? That's it? What about the hole in the oil cap? I have
a bj8 manifold on my bt7 engine. I get a lot of blowby into my
rear air filter. Had Rocker arm checked...all good.<br>
<br>
<div data-smartmail="gmail_signature">Ira Erbs<br>
1959 AH 100-6<br>
1967 MGB<br>
Milwaukie, Or</div>
</div>
<br>
<div class="gmail_quote">
<div dir="ltr" class="gmail_attr">On Mon, Mar 21, 2022, 5:31 PM
Bob Spidell <<a href="mailto:bspidell@comcast.net"
moz-do-not-send="true" class="moz-txt-link-freetext">bspidell@comcast.net</a>>
wrote:<br>
</div>
<blockquote class="gmail_quote" style="margin:0 0 0
.8ex;border-left:1px #ccc solid;padding-left:1ex">Here's how
my mechanic did it. Best to balance both carbs, but using the
<br>
unused port on the manifold works OK too. I ran that way for
many <br>
years; the thread is some sort of Brit thread, I drilled and
tapped it <br>
for an American one.<br>
<br>
On 3/21/2022 10:51 AM, Michael DiVito via Healeys wrote:<br>
> Planning to install a PCV on my BJ8 and having trouble
finding the right hardware to connect to the manifold. The
plug in the manifold where I will connect the PCV is 3/8” with
a fine thread pattern. Does anyone know where I might purchase
a suitable connector which has the correct 3/8” threaded end
for the manifold connection and a 1/2” barbed end for
connection to the PCV? Also if anyone has already done a PCV
install advice appreciated.<br>
><br>
> Michael P. DiVito<br>
</blockquote>
</div>
</blockquote>
<br>
</body>
</html>