<html xmlns:v="urn:schemas-microsoft-com:vml" xmlns:o="urn:schemas-microsoft-com:office:office" xmlns:w="urn:schemas-microsoft-com:office:word" xmlns:m="http://schemas.microsoft.com/office/2004/12/omml" xmlns="http://www.w3.org/TR/REC-html40"><head><meta http-equiv=Content-Type content="text/html; charset=us-ascii"><meta name=Generator content="Microsoft Word 15 (filtered medium)"><style><!--
/* Font Definitions */
@font-face
{font-family:"Cambria Math";
panose-1:2 4 5 3 5 4 6 3 2 4;}
@font-face
{font-family:Calibri;
panose-1:2 15 5 2 2 2 4 3 2 4;}
/* Style Definitions */
p.MsoNormal, li.MsoNormal, div.MsoNormal
{margin:0cm;
font-size:11.0pt;
font-family:"Calibri",sans-serif;
mso-fareast-language:EN-US;}
span.EmailStyle17
{mso-style-type:personal-compose;
font-family:"Calibri",sans-serif;
color:windowtext;}
.MsoChpDefault
{mso-style-type:export-only;
font-family:"Calibri",sans-serif;
mso-fareast-language:EN-US;}
@page WordSection1
{size:612.0pt 792.0pt;
margin:72.0pt 72.0pt 72.0pt 72.0pt;}
div.WordSection1
{page:WordSection1;}
--></style><!--[if gte mso 9]><xml>
<o:shapedefaults v:ext="edit" spidmax="1026" />
</xml><![endif]--><!--[if gte mso 9]><xml>
<o:shapelayout v:ext="edit">
<o:idmap v:ext="edit" data="1" />
</o:shapelayout></xml><![endif]--></head><body lang=EN-GB link="#0563C1" vlink="#954F72" style='word-wrap:break-word'><div class=WordSection1><p class=MsoNormal>It is possible to use an engine stand if it is lengthened, and the angle of the vertical piece changed so that the pivoting part is horizontal. See attached photos.<o:p></o:p></p><p class=MsoNormal><o:p> </o:p></p><p class=MsoNormal>At the front, I used similar location for an adaptor frame which had a piece of scaffolding tube sticking out from it. At the front I used an engine hoist with a large shackle to go around the scaffold tube. To stop the shackle coming off I used two large washers either side of the shackle, and a split pin to stop the washer sliding off the end of the tube. All clear on photo.<o:p></o:p></p><p class=MsoNormal><o:p> </o:p></p><p class=MsoNormal>It is important that the pivot line is approximately at the CG of the frame assy. No, I do not have a dimension, however using the arrangement described I could rotate the frame on my own. My frame could be locked at 45 degree intervals using the locking pins on the engine stand.<o:p></o:p></p><p class=MsoNormal><o:p> </o:p></p><p class=MsoNormal>Frame on castors in corner of garage is for the chassis to roll around on.<o:p></o:p></p><p class=MsoNormal><o:p> </o:p></p><p class=MsoNormal>Ian<o:p></o:p></p></div></body></html>