<div dir="auto">While disassembling the rear brakes of the BN1 that I'm restoring I noticed that 1 of the brake adjuster followers (not sure that's the correct name) appeared to be hand made. Fortunately I had a spare so replaced it.<div dir="auto">Now, I  have discovered that my replacement is incorrect. </div><div dir="auto">Only in the spiral- bevel type rear brake are these followers pairs,  i.e. not identical, and my replacement is incorrect.</div><div dir="auto">If you look at the at the attached pics you will note that when looking down the  axis of these followers when they are placed with their angle cut end on a flat surface, the slot for the shoe slopes upper left to lower right. </div><div dir="auto">This indicates that these 2 followers are the same i.e. not a pair.</div><div dir="auto">Before I start trying to make a replacement, which I  can imagine will be a very time consuming process considering that they are hardened, does anyone have one that I can purchase?</div><div dir="auto">Thanks,</div><div dir="auto"><br></div><div dir="auto">M</div></div>